Make tinted car windows with his hands (not using the services of auto service shops) is very simple and cheap. For the successful implementation of the activities you will need: patience and accuracy, as well as: 1. Film for toning – a roll is usually enough for 4 side windows. 2. Perhaps check out Coupang for more information. Rubber spatula, complete with a plastic scraper film is – in case of emergency is also nice, but it leaves mikrotsarapiny. 3.
Stationery knife – knife going in Included with the film for tinting, blunts and quickly begins to tear the material. 4. Detergent or shampoo. 5. Dry, lint-free rag.
6. Clean warm water. 7. Spray. Tinted windows of the car is better to make a friend in dust-free environment. If in the street, in a nice, calm weather. It is also useful to use the construction, installation or household dryer for quick drying car windows. At the beginning of seals and remove all my carefully intended for tinting the windows with the use of detergent. Especially good to rinse the corners. Then diluted soapy water (detergent or shampoo to clean) with warm water and pour this solution in a spray bottle. Spray the outside of the newly washed windows with soap and water applied to the film dubbing it a layer of dark inside, transparent layer outward. It is important not to confuse the party! To make it easier orientation, where some party, you can barely stratify the film from one angle. Attached to the glass and cut the film alignment, leaving all the edges of the film stock is about 1 cm then spray the soap solution inside of the glass. Then quickly (yet not had time to dry glass!) Separate the dark layer of the film, parallel to its dampening solution from an atomizer. This part is advisable to make together: a strong holding a transparent layer and the second pulling gently sprinkles and dark fiber. Are putting a dark layer to wet the inside of the glass. Again, it irrigates the spray. Then superimpose it on a transparent layer (to protect film from mechanical damage) and start with a rubber spatula to smooth from the center to the edges. Getting rid of air bubbles and smooths up until starts to fall off dried transparent film. Removing it cuts the protruding edge of the dubbing of the film, carefully guiding a sharp knife along the edge of the glass. If there is a hairdryer, then dry the glass around the perimeter. If not, then close the door and proceed to the next glass. Within two days recommend not to insert seals on the doors and not open toned glass.